While a tiler specialist can lay tiles on vertical and
horizontal surfaces with the use of thinset mortar, a person with less
experience may prefer a tile glue Strathpine with more grab for vertical installations. Many
tilers choose a polymer paste that is referred to as mastic.
These products are water-soluble and wash off tools easily.
But remember to do it before the tile adhesive dries. The job includes using a
flat substrate without bulges to prevent disrupting the work of mastic. It is
best to use fiber cement backer board.
1. Spread the tile glue Strathpine evenly over a section of the
wall. This is something that you can cover with tiles within an hour. Use the
flat surface part of the trowel. If the bond starts to set before you lay tile
on it, it does not hold properly. Make sure not to spread the adhesive over the
entire wall at once.
2. Scrape the sealant using the notched side of the
trowel. In general, the depth of the notches must be equal to the thickness of
the tile. However, the heavy tile would need deeper notches. You can ask the
tile supplier which trowel is ideal to use.
3. Begin at the top end or one end of the tile section,
in which you applied tile glue Strathpine and make long sweeping movements toward the
other end. Press hard to allow the notches scrape on the substrate below.
4. Pick a tile and place it in position on the wall.
Next, press it into the adhesive. As you release pressure, make sure it stays
in its position. push on it a little harder if it moves.
5. Put some spacers around the tile. After that, press
more tiles into place around, as you put spacers around those tiles as you continue.
Proceed until you have covered the whole section, then spread the adhesive on another
section. Repeat the process.
Warnings
·
If the substrate is frozen or work area is
below freezing, do not install tile.
·
If you get tile adhesive on your clothes,
wash it off instantly or it will be hard to remove.
·
Water-based bond is nontoxic. However, if you
use a solvent-based product, wear a respirator and keep the room well
ventilated.
Tips
·
Clean the trowel regularly. This makes it
easier to use.
·
Keep your hands clean. Keep a damp rag handy.
·
The temperature affects the setting time of adhesives,
patch materials, grouts, and mortars. Drying time increases in hot
temperatures, and slows at cold temperatures. So, plan your job accordingly.
Wall Preparation
The main purpose of preparing a wall for tile is to produce
a flat, solid, and dry surface. It should be securely attached to the wall
studs. There should be no movement to prevent damaging the installed grout and
tile. Take extra precautions for wet areas like shower walls.
Before you begin, remember that using the correct tile
glue, trowel, and mortar is vital to the success of the tile project. Indoor or
outdoor, floor or wall, the size, and tile type are all important factors.
